Novell ZENWORKS LINUX MANAGEMENT 7.3 IR2 - ADMINISTRATION GUIDE 02-12-2010 Administration Manual page 410

Back: Allows you to make changes after reviewing the summary.
Finish: Click to take the image. If you completed
when it is created.
This base image can be used in
Bundle for Automatic Imaging" on page
To create an add-on image for use in
page 419.
Configuring the ZENworks Image Bundle for Automatic Imaging
Using ZENworks Linux Management, you can install software using a bundle. Software included in
a bundle that is assigned directly is considered mandatory; the software is installed on all assigned
devices (the bundle is directly assigned to the devices, their groups, or their folders).
To configure a ZENworks Image bundle and assign devices to the bundle:
1 In the ZENworks Control Center, click the Bundles tab.
2 Click New > Bundle to start the Create New Bundle Wizard:
3 In the Create New Bundle Wizard, select Preboot bundle, then click Next.
410 Novell ZENworks 7.3 Linux Management Administration Guide
Step
Step 8 on page 412 under
410.
Step 8 on page 412, see
7, the image is assigned to the bundle
"Configuring the ZENworks Image
"Creating an Add-On Image" on