Novell ZENWORKS LINUX MANAGEMENT 7.3 IR2 - ADMINISTRATION GUIDE 02-12-2010 Administration Manual page 425

The following sections contain additional information:
"Putting Down an Image Using the Bash Prompt" on page 425
"Putting Down an Image Using the ZENworks Imaging Engine Menu" on page 425
Putting Down an Image Using the Bash Prompt
1 Use your CD- or DVD-burning software to burn the source image onto a CD or DVD.
2 Boot the device using one of the following methods:
If the device is PXE-enabled, boot it from the Preboot Services imaging server. For more
information, see
Boot the device using an imaging boot CD or DVD. For more information, see
Section 29.2.2, "Preparing Imaging Boot CDs or DVDs," on page
Boot the device from the ZENworks partition. For more information, see
ZENworks Partition" on page
3 Enter from the bash prompt.
manual
4 Insert the CD or DVD that contains the source image.
5 At the Linux prompt, enter
This mounts the CD or DVD to
6 Enter a command using the following format:
img restorel /mnt/cdrom/path/image_name.zmg
where path and image_name are the path and filename of the image relative to the root of the
CD or DVD.
7 When the imaging is done, remove the imaging boot media (if applicable) and do the following
to boot the device with the new image:
7a At the Linux prompt, type
7b Press Ctrl+Alt+Delete.
If the device doesn't boot to the new operating system (that is, if the Linux prompt is
displayed), enter
Putting Down an Image Using the ZENworks Imaging Engine Menu
1 Use your CD- or DVD-burning software to burn the source image onto a CD or DVD.
2 Boot the device using one of the following methods:
If the device is PXE-enabled, boot it from the Preboot Services imaging server. For more
information, see
Boot the device using an imaging boot CD or DVD. For more information, see
Section 29.2.2, "Preparing Imaging Boot CDs or DVDs," on page
Boot the device from the ZENworks partition. For more information, see
ZENworks Partition" on page
3 Enter from the bash prompt.
manual
4 Insert the CD or DVD that contains the source image.
5 At the Linux prompt, enter
This mounts the CD or DVD to
Section 29.2.1, "Using Preboot Services (PXE)," on page
362.
to mount the CD or DVD.
cdrom.s
.
/mnt/cdrom
, then press Enter.
lilo.s
again and reboot the device a second time.
lilo.s
Section 29.2.1, "Using Preboot Services (PXE)," on page
362.
to mount the CD or DVD.
cdrom.s
.
/mnt/cdrom
354.
354.
"Creating a
354.
354.
"Creating a
Using Preboot Services 425