Table of Contents
Advertisement
img zenPartition operation
where operation is enable, disable, or remove.
Enter
to display the ZENworks Imaging Engine menu, click Partitioning, then click
img
one of the following:
Disable ZENworks partition
Enable ZENworks partition
Remove ZENworks partition
2 Enter
to make this change effective.
lilo.s
IMPORTANT: If you remove an installed ZENworks partition, you must immediately restore a
base image with a valid non-LILO MBR (Master Boot Record). If you do not, the device cannot
boot properly.
E.8 Dump Mode (img dump)
Use the Dump mode to view information about the hard drives and partitions on the device.
1 Do one of the following:
Enter
to display the ZENworks Imaging Engine menu, click System information, then
img
click Drive information.
Enter the following:
img dump [geo]
where:
Parameter
dump
geo
Examples:
Example
img dump
img dump geo
E.9 Information Mode (img info)
Use the Information mode to view the following:
The data currently stored in the image-safe area on the device
Action
Lists the existing partitions on all local hard drives. For each partition, the
type, size, and slot number of the partition are given.
The ZENworks partition and Dell or Compaq configuration partitions are
not listed.
Displays additional information about the geometry (cylinders, heads, and
sectors) and capacity of each hard drive.
Explanation
Lists the current partitions on all local writable devices.
Lists all hard drives, their geometry and capacity, and the current
partitions on the writable devices.
ZENworks Imaging Engine Commands 643
Advertisement
Table of Contents
