Novell ZENWORKS LINUX MANAGEMENT 7.3 IR2 - ADMINISTRATION GUIDE 02-12-2010 Administration Manual page 405

Disabling the Persistent Network Device Names for SLES 9 / NLD
You must rename the Ethernet configuration file to initialize the Ethernet devices on boot.
1 Go to
/etc/sysconfig/network
2 Find the
ifcfg-eth
Ethernet device represents the MAC address for the device.
For example,
In the ifcfg-eth-id-00:AA:BB:11:22:33 file, the trailing identifier,
AA:BB:22:33, is the MAC address for the device.
3 Rename the file to
ifcfg-ethX,
system. For example, the name for the configuration
Disabling the Persistent Storage Device Names
To disable the persistent storage device names for SLES9/SLES10/SLED9/SLED10:
1 Search for the
/dev/disk/by-*
and the file system table
menu.lst
2 Store the mapping of
dev/disk/by-* > /tmp/scratchpad.txt
3 Remove storage-specific entries, such as SAN or iSCSI volumes, that are not local to the
system.
4 In
/boot//grub/menu.lst and/etc/fstab
the scratch file with the device names the symlinks point to.
5 Reboot the device.
.
file for each Ethernet device. In the filename, the trailing identifier for an
where X represents the number of Ethernet devices on the
references in the boot loader configuration file
/etc/fstab.
symlinks to their targets in a scratch file:
/dev/disk/by-*
.
is
eth0 ifcfg-eth0
files, replace the
/dev/disk/by-*
.
/boot/grub/
ls -l /
entries from
Setting Up Preboot Services 405