Novell ZENWORKS LINUX MANAGEMENT 7.3 IR2 - ADMINISTRATION GUIDE 02-12-2010 Administration Manual page 408

"Configuring the ZENworks Image Bundle for Automatic Imaging" on page 410
"Imaging a Device Using a Script" on page 414
Taking a Base Image of a Device
A base image is an image of all partitions and data on a source device's hard disks. Normally, such
an image is prepared with the intent to completely replace the contents of a target device's hard
disks.
You can take an image of an existing device and use it to image a similar device, or use it as a
backup image for reimaging the device.
1 In the ZENworks Control Center, click the Devices tab.
2 Click Servers or Workstations, then select the check box next to a device.
This selects the device for taking the image.
3 Click Actions > Take image.
You can also select the check box next to Servers or Workstations to start this wizard, then click
Actions > Take image. If you do so, you are asked to select a device from the group. Then the
File Information page is displayed.
4 Click Next to display the File Information page:
5 Fill in the fields:
408 Novell ZENworks 7.3 Linux Management Administration Guide