Novell ZENWORKS LINUX MANAGEMENT 7.3 IR2 - ADMINISTRATION GUIDE 02-12-2010 Administration Manual page 644

This data is saved by the Novell ZENworks Linux Management Imaging Agent (novell-zislnx)
during each device's session to ensure that it can be restored after the device is reimaged. If the
device is new and doesn't have an operating system yet, an initial set of data is supplied from
the default configuration for the ZENworks Management Zone, such as IP addresses.
Information about the hardware devices on the device
This information is detected during the imaging boot process. If the ZENworks Imaging Engine
runs in auto-imaging mode, this information is sent to the imaging server to help determine
which image to put on the device, if necessary.
Name of the base image that was last put down on the device
To use the Information mode:
1 Enter
Image-safe data or Detected hardware. (See
or
Enter the following from the bash prompt:
img info [zisd]
Commands
Table E-11
Menu item or parameter
System Information >
Detected Hardware
or
info (from the bash
prompt)
System Information >
Image Safe Data
or
img info zisd (from the
bash prompt)
644 Novell ZENworks 7.3 Linux Management Administration Guide
to display the ZENworks Imaging Engine menu, click System information, then click
img
Information Mode Parameters
Action
Lists the detected hardware devices on the device, including:
CPU chipset
BIOS asset tag
BIOS serial number
Video adapter
Network adapter
MAC address
Sound card
Hard drive controller
Hard disk capacity
Detected RAM
Boot media
Lists the data currently stored in the image-safe area on the device. The items
that comprise this data are listed in
Editor (zisview and zisedit)," on page
In addition to the image-safe data, the last base image that was put down on
the device is also listed.
Table E-11 for details.)
Section D.3, "Image-Safe Data Viewer and
613.