Imaging Configuration Parameters (Settings.txt) - Novell ZENWORKS LINUX MANAGEMENT 7.3 IR2 - ADMINISTRATION GUIDE 02-12-2010 Administration Manual

The
zmediacreator.exe
zmediacreator.exe
For instructions on using the utility, see
Creator," on page
D.5 Imaging Configuration Parameters
(settings.txt)
The
settings.txt
copy is located in the
server where ZENworks Linux Management is installed. You should maintain the working copy of
settings.txt
Settings.txt
parameter has the general format of PARAMETER=value. Lines that begin with a pound sign (#)
signify comments and are ignored during the imaging boot process.
You can edit this file manually in a text editor, or by making configuration changes in the
zimgboot.exe
(zmediacreator.exe)," on page
IMPORTANT: If you manually edit the
make sure that you provide the full path, or the executable might not run.
The format and function of each parameter in the
Settings.txt File Parameters
Table D-4
Parameter
PROMPT
618 Novell ZENworks 7.3 Linux Management Administration Guide
file is located at
on your ZENworks Linux Management imaging server.
Section 29.2.3, "Using the ZENworks Imaging Media
356.
file contains parameters that control how the imaging boot process occurs. A
/opt/novell/zenworks/zdm/imaging/winutils
at the root of the imaging boot device (CD or DVD, or ZENworks partition).
is a plain text file that contains various parameters, each on a separate line. Each
utility (see Section D.4, "ZENworks Imaging Floppy Boot Disk Creator
617).
Specifies
Specifies whether to prompt for each configuration setting when you
boot a device from the imaging boot media.
If you leave this parameter commented out or set it to No, the device
boots using the configuration settings specified in
you can't override the settings when booting, unless you type
at the boot prompt before the Linux operating system begins to load.
If you set this parameter to Yes, you are automatically prompted for
each configuration setting when booting.
/opt/novell/zenworks/zdm/imaging/winutils/
file to provide any paths to executables,
settings.txt
file are described in
settings.txt
directory on the imaging
Table D-4:
and
settings.txt
config