Table of Contents
Advertisement
B.5 Relative to Refresh
Select the initial delay and repeat frequency to run the scheduled event and set other restrictions that
might apply.
Schedule Execution: Select one of the following options:
Start Immediately on Refresh: Select this option to run the scheduled event when the device
refreshes (looks for new bundles, policies, and so forth). The event runs on the first device
refresh only and does not run on subsequent refreshes. By default, the system global refresh
schedule is every two hours.
To change the default refresh schedule, click the Configuration tab > Device Refresh Schedule.
If the user performs a manual refresh on the device by running the
scheduled action runs on the first manual refresh only and not on subsequent refreshes (manual
refreshes or global refreshes).
Delay Execution after Refresh: Select this option to run the scheduled event for a specified
number of days, hours, or minutes after the device refreshes (looks for new bundles, policies,
and so forth).
After Executing, Repeat Every: Select this option and specify the number of days, hours, and
minutes after which you want to repeat execution of the scheduled event after a successful
execution.
Set the "Black Out" Time Ranges when Execution Should Not Occur: Click Add to display the
Specify Black-Out Time Period dialog box. Use the Start/End date and the Start/End time options to
specify the time period in which you do not want the scheduled event run. You can use this option to
minimize network traffic during a certain time period.
604 Novell ZENworks 7.3 Linux Management Administration Guide
command, the
rug ref
Advertisement
Table of Contents
