Novell ZENWORKS LINUX MANAGEMENT 7.3 IR2 - ADMINISTRATION GUIDE 02-12-2010 Administration Manual page 426

6 Enter
7 Click Imaging, then click Restore image.
8 Click Local, then click Next.
9 Browse to and specify the path to the image archive.
10 (Optional) Specify a file set.
11 (Optional) Specify any advanced options, such as sfileset or apartition:ppartition.
For details on this and other related
Commands" on page
12 Click Next.
Depending on the size of the image, it might take several minutes to put the image down.
Images usually take slightly longer to put down than they do to take.
13 When the imaging is done, remove the imaging boot media (if applicable) and do the following
to boot the device with the new image:
13a At the Linux prompt, type
13b Press Ctrl+Alt+Delete.
If the device doesn't boot to the new operating system (that is, if the Linux prompt is
displayed), enter
Using a Hard Disk for Disconnected Imaging Operations
When you boot a device from a ZENworks Linux Management imaging boot media, you can create
an image on, or put down an image from, any primary partition on an IDE or SCSI hard drive. You
can also use the local ZENworks partition if one is installed. Any target partition must have
sufficient space.
When you create an image, the partition where you store the image is itself excluded from the
image. When you put down an image, the source partition is not altered.
You can create or put down an image on a hard disk using either the bash prompt or using the
ZENworks Imaging Engine menu.
The following sections contain the instructions:
"Creating an Image Using the Bash Prompt" on page 426
"Creating an Image Using the ZENworks Imaging Engine Menu" on page 427
"Putting Down an Image Using the Bash Prompt" on page 428
"Putting Down an Image Using the ZENworks Imaging Engine Menu" on page 428
Creating an Image Using the Bash Prompt
1 Boot the device using one of the following methods:
If the device is PXE-enabled, boot it from the Preboot Services imaging server. For more
information, see
Boot the device using an imaging boot CD or DVD. For more information, see
Section 29.2.2, "Preparing Imaging Boot CDs or DVDs," on page
Boot the device from the ZENworks partition. For more information, see
ZENworks Partition" on page
426 Novell ZENworks 7.3 Linux Management Administration Guide
to display the ZENworks Imaging Engine menu.
img
631.
again and reboot the device a second time.
lilo.s
Section 29.2.1, "Using Preboot Services (PXE)," on page
parameters, see "ZENworks Imaging Engine
img
, then press Enter.
lilo.s
362.
354.
354.
"Creating a