Novell ZENWORKS LINUX MANAGEMENT 7.3 IR2 - ADMINISTRATION GUIDE 02-12-2010 Administration Manual page 428

Author: The name of the person creating this image.
Computer: The name of the computer being imaged.
Image description: A description of the image.
Comments: Any additional comments about the image.
12 Click Next.
Depending on the amount of data on the hard disk, the image might take several minutes to
create.
13 After the image is created, exit from the ZENworks Imaging Engine menu, remove any CD or
DVD from the drive, then reboot the device.
14 (Optional) Verify that the image file was created. You might also want to check its size.
Putting Down an Image Using the Bash Prompt
1 Boot the device using one of the following methods:
If the device is PXE-enabled, boot it from the Preboot Services imaging server. For more
information, see
Boot the device using an imaging boot CD or DVD. For more information, see
Section 29.2.2, "Preparing Imaging Boot CDs or DVDs," on page
Boot the device from the ZENworks partition. For more information, see
ZENworks Partition" on page
2 Enter
3 (Optional) At the Linux prompt, enter
For your information, note the number of the partition where the source image is stored.
4 Enter a command using the following format:
img restorel[pNumber] /path/image.zmg
where pNumber is the number of the partition where the source image is stored, and path and
image are the image path and filename relative to the partition root. If you omit the partition
number, the local ZENworks partition is used.
For details on other related
Commands" on page
5 When the imaging is done, remove the imaging boot media (if applicable) and do the following
to boot the device with the new image:
5a At the Linux prompt, type
5b Press Ctrl+Alt+Delete.
If the device doesn't boot to the new operating system (that is, if the Linux prompt is
displayed), enter
Putting Down an Image Using the ZENworks Imaging Engine Menu
1 Boot the device using one of the following methods:
If the device is PXE-enabled, boot it from the Preboot Services imaging server. For more
information, see
428 Novell ZENworks 7.3 Linux Management Administration Guide
Section 29.2.1, "Using Preboot Services (PXE)," on page
from the bash prompt.
manual
img
631.
again and reboot the device a second time.
lilo.s
Section 29.2.1, "Using Preboot Services (PXE)," on page
362.
to view the available partitions.
img dump
command parameters, see
, then press Enter.
lilo.s
354.
354.
"Creating a
"ZENworks Imaging Engine
354.