Generating Reports - Novell ZENWORKS LINUX MANAGEMENT 7.3 IR2 - ADMINISTRATION GUIDE 02-12-2010 Administration Manual

Field
General
Columns
Filters
Generate
Apply
Reset
4 To generate the report, click Generate.

42.5 Generating Reports

You can generate an existing report, or generate multiple reports simultaneously. After the system
displays the report, you can print the information or export and view the data in HTML, CSV, or
XML formats.
1 In the ZENworks Control Center, click the Reports tab.
2 To generate a report, select the report's check box, then click Generate.
or
3 To generate a batch of reports, select the report folder's check box, then click Generate.
You can also select individual reports and run them simultaneously.
The following graphic is a sample of a generated ZENworks report.
Description
Revise the report description.
Add, delete, or change the column layout and sorting details of the
report. See Section 42.2, "Creating a Report," on page 536
information about adding columns to a report.
Novell recommends that you use the Message From This Type
Object column only in conjunction with other message and device
columns and filters. If you add other types of columns or filters, the
message displayed in this column might be inaccurate. Known
exceptions of device columns and filters that also cause this
inaccuracy are
Device Code Page
Device Virtual Memory
Device Visible Memory
Revise, add, or delete the report filters. See
Report," on page 536 for more information about naming, formatting,
and filtering.
Runs the report based on the settings displayed on the page. See
Section 42.5, "Generating Reports," on page 541
information.
Saves the new settings.
Resets the report to its original settings.
for more
Section 42.2, "Creating a
for more
Generating ZENworks Reports 541