Egress Set; Qos Priority; Figure 188 Wrr Command Example; Figure 189 Egress Set Command Example - ZyXEL Communications GS-4012F/4024 User Manual

GS-4012F/4024 User's Guide

Figure 188 wrr Command Example

ras# configure
ras(config)# interface port-channel 2,6-12
ras(config-interface)# wrr
ras(config-interface)# wrr 8 7 6 5 4 3 2 1

41.8.12 egress set

Syntax:
where
<port-list>
An example is shown next.
• Enable port-based VLAN tagging on the switch.
• Enable ports one, three, four and five for configuration.
• Set the outgoing traffic ports as the CPU (0), seven (7), eight (8) and nine (9).

Figure 189 egress set Command Example

ras(config)# vlan-type port-based
ras(config)# interface port-channel 1,3-5
ras(config-interface)# egress set 0,7-9

41.8.13 qos priority

Syntax:
where
<0 .. 7>
An example is shown next.
• Enable ports one, three, four and five for configuration.
• Set the IEEE 802.1p quality of service priority as four (4).
285
egress set <port-list>
Sets the outgoing traffic port list for a port-based VLAN.
qos priority <0 .. 7>
Sets the quality of service priority for a port.
Chapter 41 Command Examples