Setting Up - Omron E5EK - MANUAL 2 User Manual

2.1 Setting up

+ Draw-out
Fixing Screw for
Front Panel
2–2
Set up the output units for control outputs 1 and 2 before mounting the
controller.
When setting up the output units, draw out the internal mechanism
from the housing and insert the output units into the sockets for control
outputs 1 and 2.
When drawing out the internal mechanism from the housing, prepare a
phillips screwdriver matched to the size of the screw on the lower part of
the front panel.
(1) Press down strongly on the hook on the top of the front panel, and
turn the Phillips screws to the left to loosen the screw on the lower
part of the front panel.
(2) Draw out the internal mechanism towards you holding both sides of
the front panel.
Tighten this screw by a torque of 0.3 to 0.5 N m.
Press down here strongly