Omron E5EK - MANUAL 2 User Manual page 86

Alarm 1 type
Alarm 2 type
Alarm 3 type
Alarm 1 to 3 type" parameters specify the operation of the alarm by the one of the
set values in the following table. For details of operation at an alarm, see page 3 10.
Function
Set Value
1
Comment
2
3
4
5
6
Defaults: 2 (Deviation upper limit)
F Related article
3.4 Setting Alarm Type (page 3 10)
F Related parameters
See
Alarm value 1" Alarm value 2" Alarm value 3" (level 1 mode)
Alarm 1 hysteresis" Alarm 2 hysteresis" Alarm 3 hysteresis" (level 2 mode)
Alarm 1 open in alarm" Alarm 2 open in alarm" Alarm 3 open in alarm" Control
output 1 assignment" Control output 2 assignment" Auxiliary output 1 assign
ment" Auxiliary output 2 assignment" (setup mode)
Settings
Upper-and lower-limit alarm
(deviation)
Upper-limit alarm (deviation)
Lower-limit alarm (deviation)
Upper-and lower-limit range alarm
(deviation)
Upper-and lower-limit alarm with
standby sequence (deviation)
Upper-limit alarm with standby
sequence (deviation)
Setup Mode
Conditions of Use
Alarms must be assigned as outputs. For
example, if alarm outputs 1 and 2 only are
assigned as outputs, the "alarm 3 type"
parameter cannot be used.
Set Value
7
Lower-limit alarm with standby
sequence (deviation)
8
Absolute-value upper-limit alarm
9
Absolute-value lower-limit alarm
10
Absolute-value upper-limit alarm with
standby sequence
11
Absolute-value lower-limit alarm with
standby sequence
Settings
5–29