Omron E5EK - MANUAL 2 User Manual page 64

PV/SP
The process value is displayed on the No.1 display, and the set point is displayed on
the No.2 display. The set point can be set.
Either of the local SP or remote SP is displayed as the set point depending on the SP
Function
mode. In the remote SP mode, the set point is only monitored.
The decimal point position is dependent on the selected sensor during temperature
input and on the results of scaling during analog input.
Process value
Scaling lower limit -10%FS to scaling upper limit +10%FS
Comment
During temperature input, the range of the currently selected sensor is taken as the
monitor range.
Set point
Local SP : Local SP lower setting limit to local SP setting upper limit
Remote SP: Remote SP lower setting limit to remote SP upper limit
F Related article
3.7 Adjusting Control Operation (page 3 15)
F Related parameters
See
Input type" Scaling upper limit" Scaling lower limit" Decimal point" (setup mode)
SP setting upper limit" SP setting lower limit" (expansion mode)
SP mode" (level 2 mode)
Remote SP enable" Remote SP upper limit" Remote SP lower limit" (option
mode)
Local SP mode
Process value
Set point
[RSP] LED not lit
Monitor Range
Setting Range/Monitor Range
Level 0 Mode
Remote SP mode
Monitor only
[RSP] LED lit
Unit
EU
Unit
EU
EU
Default
0
-
5–7