Omron E5EK - MANUAL 2 User Manual page 76

SP ramp time unit
SP ramp set value
Specifies the change rate during SP ramp operation. Set the maximum permissible
change width per unit of time (minute or hour) as the SP ramp set value". However,
note that when set to 0", the SP ramp function is disabled.
Function
The time unit and SP ramp set value are independent of each other. For example,
when setting 30 per minute", set the SP ramp set value" parameter to 30" and the
SP ramp time unit" parameter to [
time unit only to [
During temperature input, the decimal point position of the SP ramp set value is
dependent on the currently selected sensor, and during analog input on the results
of scaling.
SP ramp time unit
SP ramp set value
Comment
During temperature input, the range of the currently selected sensor it taken as the
setting range for the SP ramp set value" parameter.
F Related article
4.2 Operating Condition Restrictions/SP ramp (page 4 5)
F Related parameters
See
Input type" Scaling upper limit" Scaling lower limit" Decimal point" (setup
mode)
] (hour"), the set time becomes 30 per hour."
Parameter
[ ]: minute/
Level 2 Mode
] (minute"). However, if you change the
Setting Range
[ ]: hour
0 to 9999
Unit Default
None
EU 0
5–19