SP tracking enable
Specifies the operation when the remote SP mode is switched to the local SP mode.
When this parameter is set to ON", the local SP is changed to the remote SP value.
When this parameter is set to OFF", the local SP is not influenced by the remote SP .
Function
[
Comment
F Related article
4.3 How to Use the Remote SP (page 4 7)
F Related parameters
See
Set point during SP ramp" (level 0 mode)
SP mode" (level 2 mode)
Setting Range
]: Enabled/[
]: Disabled
Option Mode
Conditions of Use
The remote SP function must be enabled.
Default
[
]
5–41