Omron E5EK - MANUAL 2 User Manual page 142

Mode Parameter Name
Input type
Scaling upper limit
Scaling lower limit
Decimal point
_C/_F selection
Parameter initialize
Control output 1 assignment
Control output 2 assignment
Auxiliary output 1 assignment
Auxiliary output 2 assignment
Setup Setu
Alarm 1 type
Alarm 1 open in alarm
Alarm 2 type
Alarm 2 open in alarm
Alarm 3 type
Alarm 3 open in alarm
Direct/Reverse operation
SP setting upper limit
SP setting lower limit
PID/ON/OFF
Expan- E
AT calculated gain
sion sion
Standby sequence reset set-
ting method
Automatic return of display
mode
AT hysteresis
LBA detection width
*4
When temperature input is selected, the sensor range selected in the input type" parameter (setup mode) corresponds to the scaling upper and lower
limit value.
SETTING AND MONITORING PARAMETER LIST
Setting Range
0 to 22
Scaling lower limit +1 to 9999
-1999 to Scaling upper limit -1
0 to 3
C/F
YES/NO
HEAT/COOL/AL-1 to AL-3/HBA/LBA
HEAT/COOL/AL-1 to AL-3/HBA/LBA
AL-1 to AL-3/HBA/LBA/S.ERR/
E333/RSER
AL-1 to AL-3/HBA/LBA/S.ERR/
E333/RSER
1 to 11
N-O/N-C
1 to 11
N-O/N-C
1 to 11
N-O/N-C
OR-R/OR-D
SP setting lower limit +1 to scaling
upper limit
Scaling lower limit to SP setting
upper limit -1
PID/ON/OFF
0.00 to 1.00
0.1 to 10.0
0/1
0 to 99
0.1 to 9.9
0.0 to 999.9
Unit Default Remarks
None 2
None 100 Analog input
*4
None 0 Analog input
*4
None 0 Analog input
None C Temperature input
None NO
None HEAT
None AL-1
None AL-2
None AL-3
Output assignment
None 2
needed
Output assignment
None N-O
needed
Output assignment
None 2
needed
Output assignment
None N-O
needed
Output assignment
None 2
needed
Output assignment
None N-O
needed
None OR-R
EU 1300
EU -200
None PID
None 0.65
None 1.0
None 0
sec 0
%FS 0.2
%FS 0.2
Setting
*4
*4
A–9