Omron E5EK - MANUAL 2 User Manual page 116

7.1 Structure of Parameters
Thermocouple 1
7–2
To calibrate the E5EK DRT controller, select [
play to select the calibration mode. [
However, note that [
when, for example, the user is calibrating the E5EK DRT controller for
the first time. If this happens, [
rity" parameter (protect mode) to 0".
The parameters in the calibration mode are configured as follows.
Platinum resistance
Thermocouple
thermometer
Platinum
resistance
thermometer 1
Thermocouple 2
To select the desired parameter, press the
played in the following order:
Calibration of inputs
Only inputs that have been set in the input type" parameter (setup
mode) can be calibrated. To temporarily save data for each of the calibra
tion parameters, press the
The data save menu is displayed only when all calibration items have
temporarily been saved.
After calibrating input, you must always check indication accuracy. For
details, see page 7 12.
] may not be displayed on the menu display
] is displayed by changing the secu
Current input
Platinum
resistance
thermometer 2
Thermocouple 1 : K / J / L / E / N / W / PLII
Thermocouple 2 : K / J / L / R / S / B / T / U
Platinum resistance
: JPt100/Pt100
thermometer 1
Platinum resistance
: Pt100
thermometer 2
Saving of calibration data
key for 1 second.
] in the menu dis
] is displayed.
Voltage input
0 to 5VDC
1 to 5VDC
0 to 10VDC
key. Parameters are dis