Omron E5EK - MANUAL 2 User Manual page 88

t
The parameters in this mode can be used only when the security" parameter (pro
tect mode) is set to 0" and 1".
This mode contains the parameters for setting expanded functions. These parame
ters, for example, are for selecting the SP setting limiter, 2 PID and ON/OFF, specify
ing the standby sequence reset method, and setting the automatic return to the moni
toring display.
To select this mode when in the levels 0 to 2, setup, option and calibration modes,
press the
If you select [
mum, the controller enters the expansion mode.
To select parameters in this mode, press the
use the
The following table shows the parameters supported in this mode and the page where
the parameter is described.
key for 1 second minimum. The display changes to the menu display.
] using the
or keys.
Symbol
SP setting upper limit
SP setting lower limit
PID / ON/OFF
AT calculated gain
Standby sequence reset method
Automatic return of display mode
AT hysteresis
LBA detection width
Expansion Mode
key then press the
key. To change parameter settings,
Parameter Name
key for 1 second mini
Page
5-32
5-32
5-32
5-33
5-33
5-34
5-34
5-35
5-35
5–31