Omron E5EK - MANUAL 2 User Manual page 67

CHAPTER 5 PARAMETERS
Level 1 Mode
The parameters in this mode can be used only when the security" parameter (pro
tect mode) is set to 0" to 3".
This mode contains the main parameters for adjusting control. These parameters
include parameters for executing AT (auto tuning), setting the alarm values, setting
the control period, and setting PID parameters.
To select this mode when in the levels 0 and 2, setup, expansion, option and calibra
tion modes, press the
menu display. If you select [
1 second minimum, the controller enters the level 1 mode.
To select parameters in this mode, press the
use the
The following table shows the parameters supported in this mode and the page where
the parameter is described.
5–10
key for 1 second minimum. The display changes to the
or keys.
Symbol
AT Execute/Cancel
Alarm value 1
Alarm value 2
Alarm value 3
Proportional band
Integral time
Derivative time
Cooling coefficient
Dead band
Manual reset value
Hysteresis (heat)
Hysteresis (cool)
Control period (heat)
Control period (cool)
Heater current monitor
Heater burnout
] using the key then press the
key. To change parameter settings,
Parameter Name
key for
Page
5-11
5-11
5-11
5-11
5-12
5-12
5-12
5-12
5-13
5-13
5-14
5-14
5-15
5-15
5-15
5-16