Omron E5EK - MANUAL 2 User Manual page 79

CHAPTER 5 PARAMETERS
Level 2 Mode
Input digital filter
Sets the time constant of the input digital filter. The following figures shows the effect
on data after passing through the digital filter.
Function
Comment
Alarm 1 hysteresis
Alarm 2 hysteresis
Alarm 3 hysteresis
This parameter is for setting the hysteresis of alarm outputs 1 to 3.
Function
Comment
F Related article
3.4 Setting Alarm Type (page 3 10)
F Related parameters
See
Alarm 1 type" Alarm 2 type" Alarm 3 type" Alarm 1 open in alarm" Alarm 2 open
in alarm" Alarm 3 open in alarm" (setup mode)
Alarm value 1" Alarm value 2" Alarm value 3" (level 1 mode)
5–22
PV before passing through filter
A
Time
constant
Input digital filter
Unit
Setting Range
0 to 9999 Second
Unit
Setting Range
0.01 to 99.99 %FS
PV after passing through filter
0.63A
Time
Default
0
Conditions of Use
Alarms must be assigned as outputs. For
example, if alarm outputs 1 and 2 only are
assigned as outputs, the "alarm 3 hystere-
sis" parameter cannot be used.
Default
0.02