Omron E5EK - MANUAL 2 User Manual page 21

+ Setting up the output unit
' Before setup
' Procedure
Check the type of the output unit you are about to set up.
For details on types of output unit and main specifications, see page 2 8.
(1) Check the positions of the sockets you are about to insert the output
units into as shown in the following diagram.
OUT1
OUT2
(2) Remove the power board in the direction of the arrow shown in the
figure. The power board is connected to the control board by a center
connector. Remove this connector taking care not to bend the connec
tor pins.
Power board
(3) Insert the output unit for control output 1 into the socket OUT1"
and the output unit for control output 2 into the socket OUT2".
(4) Fasten the output units with the bracket (accessory).
(5) Return the power board to its original position.
Bracket
Control board
2–3