Omron E5EK - MANUAL 2 User Manual page 66

MV monitor (heat)
MV monitor (cool)
This parameter cannot be set.
Monitors the manipulated variable on the heating or cooling side.
The manipulated variable in a standard control system is checked in the MV moni
Function
tor (heat)" parameter.
The MV monitor (cool)" parameter can be used only during heating and cooling con
trol.
MV monitor (heat)
Standard
Monitor
Heating and cooling
MV monitor (cool)
Heating and cooling
Run/Stop
This parameter is used for checking the operating status of the controller, and for
specifying start and stop of operation.
Function
To start operation, set this parameter to [
operation, set this parameter to [
LED lights.
Example
of use
Default is [
F Related article
3.6 Starting and Stopping Operation (page 3 14)
See
Control
Monitor Range
-5.0 to 105.0
0.0 to 105.0
Control
Monitor Range
0.0 to 105.0
]
Level 0 Mode
Conditions of Use
Control must be standard control or heat-
ing and cooling control.
Unit
%
%
Unit
%
] press the
]. When operation is stopped, the STOP"
or keys. To stop
5–9