Omron E5EK - MANUAL 2 User Manual page 81

CHAPTER 5 PARAMETERS
Setup Mode
t
The parameters in this mode can be used only when the security" parameter (pro
tect mode) is set to 0" and 1".
This mode contains the parameters for setting the basic specifications of the E5EK
DRT controller. These parameters include parameters for specifying the input type,
scaling, output assignments, and direct/reverse operation.
To select this mode when in the levels 0 to 2, expansion, option and calibration modes,
press the
If you select [
mum, the controller enters the setup mode.
To select parameters in this mode, press the
use the
The following table shows the parameters supported in this mode and the page where
the parameter is described.
5–24
key for 1 second minimum. The display changes to the menu display.
] using the
or keys.
Symbol
Input type
Scaling upper limit
Scaling lower limit
Decimal point
_C/_F selection
Parameter initialize
Control output 1 assignment
Control output 2 assignment
Auxiliary output 1 assignment
Auxiliary output 2 assignment
Alarm 1 type
Alarm 1 open in alarm
Alarm 2 type
Alarm 2 open in alarm
Alarm 3 type
Alarm 3 open in alarm
Direct/Reverse operation
key then press the
key. To change parameter settings,
Parameter Name
key for 1 second mini
Page
5-25
5-26
5-26
5-26
5-27
5-26
5-27
5-27
5-28
5-28
5-29
5-30
5-29
5-30
5-29
5-30
5-30