Omron E5EK - MANUAL 2 User Manual page 93

CHAPTER 5 PARAMETERS
Option Mode
The parameters in this mode can be used only when the security" parameter (pro
tect mode) is set to 0" and 1".
You can display this mode only on controller models that support the option func
tions. In this mode, you set communications conditions and communications data
assignment parameters to match the type of option function.
To select this mode when in the levels 0 to 2, setup, expansion and calibration modes,
press the
If you select [
mum, the controller enters the option mode.
To select parameters in this mode, press the
use the
The following table shows the parameters supported in this mode and the page where
the parameter is described.
5–36
key for 1 second minimum. The display changes to the menu display.
] using the
or keys.
Symbol
Baud rate
Node address
Communication data format
Operation at communication error
Read data assignment 1 to 16
Write data assignment 1 to 16
HBA latch
Remote SP enable
Remote SP upper limit
Remote SP lower limit
SP tracking enable
key then press the
key. To change parameter settings,
Parameter Name
key for 1 second mini
Page
5-37
5-37
5-37
5-38
5-38
5-38
5-39
5-39
5-40
5-40
5-41