Omron E5EK - MANUAL 2 User Manual page 15

' Option mode
' Calibration mode
+ Selecting modes
' Menu display
' Level 0 to 2
modes
' Setup mode
' Expansion mode
' Option mode
' Calibration mode
This is the mode for setting option functions. CompBus/D (DeviceNet)
communications conditions, heater burnout alarm function, and remote
SP scaling parameters are also located in this mode.
This mode is provided so that the user can calibrate inputs.
When calibrating input, the selected input type is calibrated.
The following diagram shows the order in which modes are selected.
1 second min.
1 second min.
1 second min.
1 second min.
1 second min.
Expansion mode
1 second min.
1 second min.
Calibration mode
To select the menu display in any of the above modes (excluding the pro
tect mode and the manual mode), press the
mum. The previously specified mode is selected. For example, if you
selected the menu display while in the level 0 mode, the No.2 display
change to [ ] as shown on the left.
If you select the destination mode using the
the key for 1 second minimum when you have selected the menu dis
play, the top parameter in the specified mode is selected.
Protected modes cannot be selected. Also, the menu display does not
appear when modes are protected up to the level 1 mode.
If you select [ ] [
level 1 and level 2 modes, respectively, are selected.
These modes are selected with control still continuing.
If you select [ ] [
setup, expansion, option and calibration modes, respectively, are
selected. When these modes are selected, the control is reset. So, control
outputs and auxiliary output are turned OFF. When another mode is
selected while in these modes, reset is canceled.
1.3 Parameters and Menus
Power ON
A/M
1 second min.
Level 0 mode
Level 1 mode
Level 2 mode
A/M
Setup mode
Option mode
] or [ ] in the menu display, the level 0,
] [ ] or [
Manual mode
A/M
1 second min.
+ +
A/M
1 second min. 1 second min.
Protect mode
+
A/M
1 second min.
key for 1 second mini
or keys and press
] in the menu display, the
1–7