Protect Mode - Omron E5EK - MANUAL 2 User Manual

This mode restricts (protects) key operation to prevent unwanted key operation.
Before changing parameters in this mode, first make sure that protecting the menu
key or
To select this mode, press the
mum. To exit this mode, press the
for 1 second minimum.
The following table shows the parameters supported in this mode and the page where
the parameter is described.
Security
This parameter specifies which parameters are protected. However, note that the
protect mode and manual mode cannot be protected.
Function
When this parameter is set to 0" to 3", only the modes indicated by the f" mark
in the table below can be selected on the menu display. For example, when this param
eter is set to 2", only level 0 to 2 modes can be selected.
Comment
When this parameter is set to 4" to 6", operations in only the level 0 mode can be
selected, and the mode is not displayed on the menu display.
When this parameter is set to 5", only the PV/SP" parameter in the level 0 mode
can be used.
When this parameter is set to 6", only the PV/SP" parameter in the level 0 mode
can be displayed. (The set point cannot change.)
Default is 1". (Only the calibration mode is protected.)
F Related article
3.5 Protect Mode (page 3 13)
See
A/M
key will not cause any problems in operation.
A/M
Symbol
Mode Mode
0
Calibration
f
Option
f
Expansion
f
Setup
f
Level 2
f
Level 1
f
Level 0
f
key and key simultaneously for 1 second mini
key and key down again simultaneously
A/M
Parameter Name
Security
[A/M] key protect
Set value
1 2 3
f
f
f
f f
f f f
f f f

Protect Mode

Page
5-3
5-4
5–3