Omron E5EK - MANUAL 2 User Manual page 90

Usually use the default value.
Sets 2 PID control parameter .
Function
Setting Range
0.00 to 1.00
Comment
F Related parameter
PID / ON/OFF" (expansion mode)
See
AT calculated gain
Usually use the default value.
Sets the gain when adjusting the PID parameters by auto tuning.
To give priority to response, decrease the set value of this parameter. To give priority
Function
to stability, increase the set value of this parameter.
Setting Range
0.1 to 10.0
Comment
F Related parameters
AT Execute/Cancel" (level 1 mode)
PID / ON/OFF" (expansion mode)
See
Conditions of Use
The control must be 2-PID control.
Unit Default
None 0.65
Conditions of Use
The control must be 2-PID control.
Unit Default
None 1.0
Expansion Mode
5–33