CHAPTER 5 PARAMETERS
Level 2 Mode
Remote/Local
Switches between remote and local operation.
To change the parameter setting during remote operation, use the communications
function. To change the parameter setting during local operation, change the setting
Function
on the E5EK DRT controller.
You can check the parameter setting by both communications and on the E5EK DRT
controller regardless of whether the controller is switched to remote or local opera
tion.
[
Comment
F Related article
Chapter 6 Using the CompoBus/D (DeviceNet)
F Related parameters
See
Communication speed" Node address" (Option mode)
SP mode
Switches between remote SP and local SP .
Function
Comment
F Related article
4.3 How to Use the Remote SP (page 4 7)
F Related parameters
See
Remote SP enable"
5–18
Setting Range
]: remote / [
]: local
Setting Range
[
]: Remote SP/[
Default
[
Conditions of Use
The remote SP function must be enabled.
Default
]: Local SP
]