Omron E5EK - MANUAL 2 User Manual page 94

Baud rate
Node address
These parameters area valid when the power is turned ON again.
Set the same baud rate to the master and other slaves on the network.
Set the node addresses so that the same values are not set to the master and slaves.
Function
Baud rate" parameter
Setting Range
125, 250, 500
Comment
Node address" parameter
Setting Range
F Related article
6.3 Setting the Communications Conditions (page 6 6)
F Related parameter
See
Remote/Local" (level 2 mode)
Communication data format
This parameter is valid when the power is turned ON again.
When the communication data is a numerical value, specify its format.
When minus sign numerical values are being entered, the signed binary format is
Function
expressed as a complement.
Numerical values are expressed as follows in the BCD format:
Numerical Value
[
Comment
F Related article
6.3 Setting the Communications Conditions (page 6 6)
F Related parameter
See
Remote/Local" (level 2 mode)
Unit
kbps
Unit
0 to 63 None
BCD Symbol
-0 F
-1 A
Setting Range
] : Signed binary format/[
Default
125
Default
0
[Example]
1500=A500", 15=F015"
Unit
] : BCD format None
Option Mode
Default
5–37