Omron E5EK - MANUAL 2 User Manual page 83

CHAPTER 5 PARAMETERS
Setup Mode
Scaling upper limit
Scaling lower limit
Decimal point
This parameter can be used only when voltage input or current input is selected as
the input type.
When voltage input or current input is selected as the input type, scaling is carried
Function
out. Set the scaling upper limit in the scaling upper limit" parameter and the scaling
lower limit in the scaling lower limit" parameter.
The decimal point" parameter specifies the decimal point position of parameters
(set point, etc.) whose unit is set to EU (Engineering Unit).
Scaling upper limit, Scaling lower limit
Comment
Decimal point : default : 0 (0 digits past decimal point)
F Related article
3.2 Setting Input Specifications (page 3 4)
F Related parameter
See
Input type" (setup mode)
Parameter initialize
Returns parameter settings to their defaults. However, note that the following
parameters are not affected by execution of this parameter:
input type", scaling upper limit", scaling lower limit", decimal point", baud
Function
rate", node address" and _C/_F selection".
When this parameter is selected, [
ters, press the
Example
of use
5–26
Parameter
Scaling upper limit Scaling lower limit +1 to 9999
Scaling lower limit -1999 to scaling upper limit -1
Setting
Set Value
0 0 digits past decimal point
1 1 digit past decimal point
2 2 digits past decimal point
3 3 digits past decimal point
key to specify [
Conditions of Use
The input type must be set to analog input
(voltage or current input).
Setting Range
Example
1234
123.4
12.34
1.234
] (no") is first displayed. To initialize parame
] (yes").
Unit Default
EU 100
EU 0