Omron E5EK - MANUAL 2 User Manual page 117

' Calibration item
menu
Calibration item
parameter
Process value
' Calibration save
mark
calibration save mark
Parameters are displayed on the No.1 display, and the process value is
displayed in Hexadecimal on the No.2 display.
Normally, the process value changes by several digits. The process value
flashes, for example, when a sensor error causes the process value to
stray from the calibration target range.
When the process value display is flashing, the process value is not saved
as data even if the
Once the E5EK DRT controller has been calibrated by the user, [
is preceded by the ." mark when the calibration mode is selected.
key is pressed.
]
7–3