To Finish The Driver Installation - Planar DOME Md4/PCI Installation Manual

62
10. Select DOME board Md4/PCI, and click Next.
11. The Update Driver Warning dialog box appears.
12. Click Yes, then Next.
The Digital Signature Not Found dialog box appears.
13. Click Yes to continue the installation.
If the Digital Signature Not Found dialog box does
not appear, or you receive a warning that the driver
cannot be installed, see "Unsigned driver cannot be
loaded message" on page 84.
The system copies the driver files.
14. Remove the diskette from the disk drive when the
copying is complete.

To finish the driver installation

1. Click Finish -> Close -> Yes to restart the computer.
When the system restarts, it prompts you to select an
operating system.
2. Select Microsoft Windows 2000 Professional and
log in.
3. Right-click the desktop, and select Properties ->
Settings tab.
4. Click Display list and select Default Monitor on
DOME Md2/PCI, Md4/PCI, Md5/PCI, or Md8/PCI.
5. Click Advanced -> Adapter tab -> List All Modes
button, highlight the desired resolution and refresh
rate, then click OK.
6. Click Apply -> OK from the Default Monitor and
DOME Md2/PCI, Md4/PCI, Md5/PCI, or Md8/PCI
Properties dialog box.
Chapter 2