Planar DOME Md4/PCI Installation Manual page 92

76
Restoring the original modes
You can restore your original mode settings after you have
modified the configuration. This list provides important
information about restoring the original modes:
• The original configuration is stored in a
you make changes that affect the configuration (such as
adding, deleting, or modifying syncs), the system writes
the changes to a
unchanged.
• The name of the
board type. For example, the Md4/PCI board files are
named
• At boot time, the driver uses the
otherwise, it uses the
the driver does not read the
To restore the original modes
1. Click Restore Original Mode List in the Custom Syncs
dialog box.
The control panel restores the original
deleting the
ing that the original modes have been restored.
2. Click OK to close the Display Properties dialog box.
3. Click Restart to restart your system.
When the computer restarts, it loads the
To load a custom
change its suffix to
dir>\system32\drivers
the computer.
file. The
.dom
and
.cfg
and
md4pci.dom md4pci.cfg
.cfg
file. A dialog box appears, explain-
.dom
file created in Windows NT 4.0,
.cfg
, move it to the
.dom
directory, and then restart
file. When
.cfg
file remains
.cfg
files derive from the
.dom
.
file if it exists;
.dom
file. If the file exists,
.dom
file.
.cfg
file by
.cfg
.cfg
<windows
Chapter 2
file.