Planar DOME Md4/PCI Installation Manual page 142

126
3. Type this command at the boot prompt:
>>>set pci_device_override 2309105d
This command allows the DOME display board to be
recognized in a 64-bit slot.
4. Turn off the power to your workstation.
5. Remove the Digital display board from the 64-bit slot
6. Enable VGA mode on the Md4/PCI board by following
the instructions in "To enable VGA mode" on page 127.
7. Attach the VGA ribbon cable to the Md4/PCI board.
(The connector is keyed to ensure it is plugged in
correctly.)
8. Install the Md4/PCI board in one of the 64-bit slots.
Follow the steps in "To install the board" on page 124.
Chapter 4