Installing the Md4/PCI Board in a Sun PCI Workstation
Connecting the Monitors
After the board is installed in your Sun PCI workstation,
connect the monitor(s) to the board with the cable. Gray-
scale cables have two branches, each with three connectors.
Color cables have one branch with five connectors.
To connect the monitors to the board
1. Attach the D-shell connector to the Md4/PCI board,
securing the connection with the screws on the
connector. Refer to your monitor documentation for
more information about connector assignments.
2. Attach each output cable to the appropriate BNC
terminal on your monitor.
Connecting the
cable to a
grayscale monitor
The cable labeling in the illustrations above applies to
the DOME Md4/PCI cable. If you are using a cable
from another source, the cable labeling may differ.
Connecting the
cable to a
color monitor
91