Planar DOME Md4/PCI Installation Manual page 54

38
The Detected Adapter dialog box appears.
The dialog box on your screen displays the values that
exist in your binary
from the values displayed in this illustration. For
information on editing these values, see "Customizing
sync parameters for Windows NT" on page 136.
4. Select the desired resolution and refresh rate, and
click OK.
Your monitor(s) must be connected to test the
resolution and refresh rate.
5. Click Test.
The Testing Mode dialog box appears, explaining that
the new mode will be tested.
6. Click OK.
A test bitmap appears, and then the Testing Mode
dialog box appears, prompting you:
Did you see the test bitmap properly?
7. Click Yes if the test bitmap displayed correctly.
file, which may be different
.cfg
Chapter 2