Planar DOME Md4/PCI Installation Manual page 133

Installing the Md4/PCI Board in a Digital UNIX Workstation
The
set_dome_monitor
information about each DOME board and its monitors,
beginning with board 0 (zero). The program will continue
to prompt you for information until you indicate that you
have no additional boards by typing 0 (zero).
To use set_dome_monitor
1. Read the on-screen information, and respond to all
questions.
Respond only with information about the DOME
boards in your system.
2. Select the board type for board zero (0) from the list
provided.
The program verifies each of your responses by asking
you to respond with a
selected the correct option. For example, if you select
two (2) for board type, the system prompts you with
this question:
You've selected "md4pci"; is that correct
[y, n]?
3. Type
different response.
4. Select the number that corresponds to your monitor
type from the list provided. When you do, be sure to
select your specific monitor, based on resolution,
refresh rate, and whether it is monochrome or color.
5. Type in the viewable width of the monitor, indicating
whether you are using inches or millimeters. For exam-
ple, type
program prompts you for
or
y
to confirm your answer, or
y
.
290 mm
to indicate whether you
n
to enter a
n
117