Planar DOME Md4/PCI Installation Manual page 44

28
3. Make sure the board connector pins are aligned with
the slot.
Installed
Md4/PCI board
4. Secure the mounting bracket with the bracket screw.
If you are not supporting VGA with the DOME board,
go to step 8.
5. Remove a blank bracket from the back of the slot you
choose for the VGA output.
6. Insert the VGA bracket and secure the mounting
bracket with the bracket screw.
7. Attach the VGA monitor to the 15-pin connector.
8. Replace the system unit cover.
Chapter 2