Running The Setld Program - Planar DOME Md4/PCI Installation Manual

116

Running the setld program

Digital provides the
uninstall kits on your Digital UNIX system. You must run
setld
cleanly remove the kit from your system. Use the
option to indicate to
To run the setld program
To run
# setld -l /mnt
The
setld
set_dome_monitor
type of monitor you intend to connect to each DOME
board. When you enter the type of monitor you are
using, the
your DOME display driver to support that monitor. It
records this information in your driver configuration file,
/usr/opt/DOM103/sysconfigtab
You can later change this configuration information by
running
Display Monitor" on page 131 for more information.
Using set_dome_monitor
The
set_dome_monitor
the
setld
• Type of board (for example, "
• Type of monitor (for example, "
Gray
• Width of monitor
• Height of monitor
setld
to load the kit. You can also run
setld
, type:
setld
program loads the kit and invokes
, which allows you to describe the
program automatically configures
setld
set_dome_monitor
script runs automatically from
program. It prompts you for this information:
")
program to load, list, and
later to
setld
where it can find the kit.
.
again. See "Configuring the
")
md4pci
1728 x 2304 at 69 Hz
Chapter 4
-l