Table of Contents
Advertisement
74
To customize or add modes
1. Connect a monitor to your installed DOME board.
2. Return to the Settings tab and select the test display
from the Display list.
3. Make sure Extend my Windows desktop onto this
monitor is selected, and click Apply.
The display extends to the selected test display.
4. Click Advanced -> DOME tab -> Custom Mode.
Do not test custom modes with the primary display or
any sister devices attached to the primary display.
5. Highlight the Resolution of the mode you want to
change.
6. Edit the Mode Values section of the dialog box to
create the mode you want.
7. Click Test.
The Display Resolution dialog box appears. The system
is about to test the customized resolution.
8. Click OK to test the mode or Cancel to abort testing.
You must test a mode before you can save it.
The test pattern displays on the screen you selected in
the Settings tab.
A message appears indicating that the new mode is
about to be tested.
9. Click OK.
10. Click Save Mode -> OK to save the mode.
Chapter 2
Advertisement
Table of Contents
Troubleshooting
