Planar DOME Md4/PCI Installation Manual page 91

Installing the Md4/PCI Board in a PC
If your edits result in a new mode (that is, the X, Y, BPP,
and refresh rate is not already included in the configu-
ration file), the control panel adds the new mode to the
.dom
If your edits result in a refresh rate that matches the
whole-number value of an existing refresh rate for an
existing resolution, the mode corresponding to the new
refresh rate overwrites the mode corresponding to the
existing refresh rate in the
For example, assume you are editing a mode of
1728 x 2304 x 8 with a refresh rate of 69.04 Hz. If
you make changes that result in a new refresh
rate of 69.4 Hz, 1024 x 768 x 8 @ 69.4 Hz replaces
1728 x 2304 x 8 @ 69.04 Hz when you save the mode.
11. Click OK to close the Display Properties dialog box and
Restart your system.
You must restart your system for the new mode to
take effect. The device driver cannot recognize
changes to the configuration file until you restart.
To remove modes
You can remove any mode except the current mode.
1. Highlight the resolution for the mode you want to
remove, and click Remove Mode.
A dialog box asks whether you are sure you want to
remove the mode.
2. Click Yes to remove the mode, or No to cancel.
3. Click OK to close the Display Properties dialog box and
Restart your system.
Settings take effect after you restart the system.
file.
file.
.dom
75