Planar DOME Md4/PCI Installation Manual page 42

26
To enable VGA mode
You must enable VGA on the Md4/PCI board if you are
using it to support VGA. To enable VGA, slide the DIP
switches on switch S1 into the positions shown in this table.
Positions to Enable VGA
DIP Switch
To disable VGA mode
You must disable VGA mode on the Md4/PCI board if you
are using it with another VGA board. You must also dis-
able VGA on additional Md4/PCI boards if you are install-
ing more than one.
To disable VGA, slide the DIP switches on switch S1 into
the positions shown in this table.
Positions to Disable VGA
DIP Switch
S1 DIP Switch
Position
1 ON
2 OFF
3 OFF
4 ON
S1 DIP Switch
Position
1 OFF
2 ON
3 OFF
4 ON
Chapter 2