Planar DOME Md4/PCI Installation Manual page 84

68
To change the resolution and refresh rate
1. Select a resolution and refresh rate from the DOME tab,
and click Apply.
When you use the DOME tab to set the resolution and
refresh rate for one of the displays of a dual-headed
DOME display board, the second display will assume
the same resolution and refresh rate.
The DOME Display Resolution dialog box appears.
2. Click OK within 15 seconds to accept the new settings.
Ignore the message to revert to the original settings.
The resolution changes on both installed screens, and a
message appears prompting you to accept or cancel the
new resolution.
3. Click OK to set this resolution, or Cancel to return to
the DOME tab.
If you select OK, this message appears.
4. Click OK. You can now use the display.
Chapter 2