Table of Contents
Advertisement
112
To run the setld program
The
setld
kits on your Digital UNIX system. You must run
load the kit. You can also run
remove the kit from your system. Use the
indicate to
To run
# setld -l /mnt
The
setld
set_dome_monitor
the type of monitor you will connect to each DOME board.
When you enter the type of monitor you are using, the
setld
display driver to support that monitor. It records this
information in your driver configuration file,
/usr/opt/DOM103/sysconfigtab
To change this configuration information, run
set_dome_monitor
Monitor" on page 127 for more information.
To use set_dome_monitor
The
set_dome_monitor
the
setld
• Type of board (for example, "
• Type of monitor (for example, "
Gray
• Width of the monitor
• Height of the monitor
program enables you to load, list, and uninstall
where it can find the kit.
setld
, type:
setld
program loads the kit and invokes the
program. This allows you to describe
program automatically configures your DOME
again. See "Configuring the Display
script runs automatically from
program. It prompts you for this information:
")
setld
later to cleanly
setld
option to
-l
.
")
md4pcx
2304 x 1728 at 65 Hz
Chapter 4
to
Advertisement
Table of Contents
