Table of Contents
Advertisement
Info
Error
Display
- L
"Lamp" ERROR
- P
SMPS ERROR
- t
Temperature ERROR
E 1
Formatter ERROR
E 2
I
2
C Panellink Out
E 3
I
2
C AD9887
E 4
I
2
C Video Input
E 5
2
I
C Decoder
E c
I
2
C SCL Line
E d
I
2
C SDA Line
E L
LPS down, reduced power
F 2
I
2
C Motor Driver
F 4
CPU Flash read
F 5
CPU Flash write
F 6
CPU Flash clear
F 7
CPU Flash format
F 8
CPU Flash command busy
F 9
CPU Flash command time out
H 0
COMM PORT TX Busy
H 1
COMM PORT RX Timeout
H 2
COMM PORT RX Data
H 3
COMM PORT RX Error
H 4
COMM PORT Source Number
H 5
COMM PORT TX Timeout
R5976820 SLM R12+ PERFORMER 08/03/2005
Error Description
Indicates an error concerning the lamp. This can be:
•
an error concerning the LPS
•
an error on the lamp info module
If it concerns an error on the lamp info module, "Wrong Lamp
Parameter(s) is displayed on the LCD display.
Indicates an error concerning the SMPS.
Projector has been shut down due to temperature reasons. This can
be:
•
DMD temperature is out of range.
Indicates an error concerning the formatter. This can be:
•
No I2C communication (no acknowledge) with the formatter board
•
Formatter error (see menu "SERVICE/DIAGNOSIS/FORMAT-
TER")
No I
2
C communication (no acknowledge) with Panellink Out EEPROM.
No I
2
C communication (no acknowledge) with device AD9887 on input
selector slot 1 and 2.
No I
2
C communication (no acknowledge) with video input on slot 3
and 4.
2
No I
C communication (no acknowledge) with decoder.
The I
2
C SCL line doesn't react (held low), so no I
is possible.
The I
2
C SDA line doesn't react (held low), so no I2C communication
is possible.
At least one LPS gone down. The projector continues with reduced
power.
No I
2
C communication (no acknowledge) with motor driver.
The TX-Line of the COMM PORT is still busy when a new transmission
has to take place.
The slave device connected to the COMM PORT didn't respond after
a request sent by the projector.
The slave device connected to the COMM PORT sent an unknown
answer after a request sent by the projector.
The slave device connected to the COMM PORT answered with the
"RX error byte" after a request sent by the projector.
The projector tries to send a wrong source selection request to the
slave device connected to the COMM PORT.
The projector is unable to send a command to the slave device
connected to the COMM PORT (transmission failure).
8. Local Keypad & LCD Display
2
C communication
53
Advertisement
Table of Contents
