Table of Contents
Advertisement
3. Pull all wires of the Peltier elements and the temperature sensor into the black cable holder. Insert a Torx® screw and fixate to
the right lower fixation point of the temperature and motor control board.
Image 27-98
Cable fixation
Mounting the core tube
1. Pull all wires of the temperature sensors and Peltier elements into the core tube.
Image 27-99
Core tube mounting
2. Close the tube and push together until a click is heard (A).
3. Take the cables together and bind a wire tire around them (B).
Mounting the formatter power cables
1. Plug the plugs of the black power cables into the respective connectors (2, 3 and 4). The cables are labelled with a colored wire
tire.
R5976820 SLM R12+ PERFORMER 08/03/2005
A
A
B
B
27. Maintenance
235
Advertisement
Table of Contents
