Readjustment Of The Plungers - Barco SLM R12 Plus Service Manual

Ga2
Gb2
Ga3
Gb3
Image 27-56
Green convergence adjustment
4. Continue with re-convergence in center at the Top and the Bottom of the image as follows (using tool R847204):
- Adjust the control Gb3 for coincidence of the diagonal Green line of the Green convergence pattern with the Red line of the
Red convergence pattern in the center at the top of the image.
- Adjust the control Gb2 for coincidence of the diagonal Green line of the Green convergence pattern with the Red line of the
Red convergence pattern in the center at the bottom of the image
5. Because the different adjustments interact, step 3 and 4 have to be repeated until full coincidence of both convergence pattern
is obtained.
6. Carefully secure the position of the DMD assembly by tightening the 4 lock-down screws.

27.4.3.2.3 Readjustment of the plungers

C
AUTION
only.
For extreme convergence adjustments, possible in case after the replacement of a DMD assembly, a readjust-
ment of the plungers can be necessary.
Convergence screw is end of course
1. Turn the plunger (A) a few turns counterclockwise.
R5976820 SLM R12+ PERFORMER 08/03/2005
R
B
G
:
Do NOT adjust the plungers on the DMD assembly, if small convergence drifts have to be corrected
Gb1 adjustment
Gb2+Gb2 adjustment
Gb2 or Gb2 adjustment
Gb3: top image
Gb2: bottom image
27. Maintenance
211