Mounting The Lens Holder Ground Leads - Barco SLM R12 Plus Service Manual

27. Maintenance
1
Image 27-100
Formatter power cables
2 green formatter power connector
3 blue formatter power connector
4 red formatter power connector
2. Take the green ground lead, insert a Torx® screw and fixate into left fixation hole of the formatter interface board (1 left).
3. Take the red and blue ground lead together, insert a Torx® screw and fixate into the right fixation hole of the formatter interface
board (1 right).
4. Tie the cables and wires together as shown in image 27-100.

27.5.4.4 Mounting the lens holder ground leads

Necessary tools
Torx® driver TX10
How to mount ?
1. Check first if the metal fixation plate is mounted on the engine. If not, turn out the screw on the removed engine to take off the
plate and mount this plate on the new inserted engine.
B
Image 27-101
Fixation plate engine-lensholder
2. Take the 3 ground leads together, plus the fixation plate and fixate with a Torx® screw.
236
3 4
2
1
A
R5976820 SLM R12+ PERFORMER 08/03/2005